Exploring Electrical Circuits: Series vs. Parallel Circuits and Electromagnetism, Lecture notes of Basic Electronics

Download Exploring Electrical Circuits: Series vs. Parallel Circuits and Electromagnetism and more Lecture notes Basic Electronics in PDF only on Docsity! EXPLORING ELECTRICAL CIRCUITS Students will explore the two basic types of electrical circuits. The type depends upon how the parts of the electrical circuit are arranged. If all the electiecal parts are connected one after another, the electrical circuit is a series circuit. In a series circuit there is only one path for the electrons to flow. The disadvantage of this type of electrical circuit is that if there is a break in any part of it, then the entire circuit is opened and therefore will not allow an electrical current to flow. The second type of electrical circuit is a parallel circuit. In a parallel circuit the different electrical parts are located on separate branches therefore there are several paths for the electrons to take. If a break should occur in this type of circuit the electrons can still move through other branches. The electrical current continues to flow. Electric power is a measure of the rate at which electricity does work or provides energy. Power =voltage X current Power is expressed as watts, voltage as volt and current as amperes. Question: What voltage is required to run a 75 watt light bulb if the current is 0.5 ampere? Answer: 75 watts = volts X 0.5 amperes or 150 volts Activity 1: Creating a series circuit Symbols for Common Circuit Parts Materials: 5 pieces of insulated bell wire--- cut 2 pieces 25 cm long and three pieces 15 cm long 3 flashlight bulbs in sockets 6V battery switch Procedure: 1. Strip 2 centimeters of insulation from the ends of each wire. 2. Connect the three bulbs in a series. 3. Attach one wire to the battery 4. Attach the other to a knife switch 5. Attach a wire from the switch to the other pole of the battery making certain that the switch is open. Identify each diagram below as being a series or parallel circuit. If the diagram shows an incomplete circuit than mark it with an X. Question: 1. What voltage would be required to run a 20 watt light bulb if the current is 0.8 amperes? Electrical Circuit Graphics, NASCO, Fort Atkinson, Wisconsin, 1986. MAKING AN ELECTROMAGNET An electric current traveling through a wire creates a magnetic field; thereby creating a temporary magnet. By building and experimenting with an electromagnet students will become acquainted with the basic concepts and properties of electromagnetism. Materials: Coarse sandpaper, 30 yards of thin insulated wire, a small steel bolt and a large steel bolt, non-alkaline C or D cell batteries, rubber bands, large and small paper clips, masking tape, and a permanent magnet Procedure: 1. Use a piece of coarse sandpaper to strip the insulation off each end of one yard of thin, insulated wire. 2. Wrap the wire in neat, tight coils around the small steel bolt, leaving 4 inches of wire hanging free and uncoiled at each end. 3. Wrap two rubber bands tightly around a non-alkaline C or D cell battery. 4. Slip a small paper clip between the rubber band and the positive pole (+) of the battery. Fold the clip over the rubber band and wind the bare end of the wire around the clip. 5. Slip another small paper clip between the negative pole (-) of the battery and the rubber band. Wrap the clip around the rubber band and hook the other bare end of the wire to the clip to complete the electromagnet. 6. Test the strength of the electromagnet by trying to pick up paper clips. 7. Repeat this procedure but this time use the larger bolt. Results for small bolt: Trial Number and size of paper clips picked up Results for large bolt: Trial Number and size of paper clips picked up Questions: 1. How many coils were wrapped around the small bolt? 2. How many coils were wrapped around the large bolt? 3. Did the number of coils make a difference in the number or size of the paper clips picked up: