Download Pennsylvania Vehicle Inspection Guidelines and more Exams Nursing in PDF only on Docsity! PA state inspection categories test questions and answers How should Suspension components be maintained? - every suspension component shall be in safe operating condition how should steering components be maintained? - the steering component should be in safe operating conditions the steering wheel shall have a minimum outside diameter of ?? - 13 inches a passenger car manufactured after June 30, 1967 and designated as a 1968 or later model shall be equipped with what? - service brake system with rupture failure design that doesn't not result in complete brake loss brake lines shall be approved for use as - brake lines what shall a vehicle specified in this chapter be equipped with? - parking brake what should a parking brake be adequate to hold the vehicle on? - ice or snow on a 20% grade a radial ply tire shall not be used on? - the same axle as a belted or bias tire different types of tires - different types of tires shall not be used on the same axle unless in the event of an emergency Non-Pneumatic tires - only if originally equipped by the manufacturer and or an antique vehicle ice grips or studs - may not be equipped if they have projections greater than 2/32nds tires and rims - must meet or beat manufacturer specs spacers can be no thicker than - 1/4 inch what head lamp system should your vehicle be equipped with - two or four head lamp system low beam candle watts must be brighter than? - 7500 high beam candle watts cannot be less than? - 10,000 total candle wattage cannot exceed? - 150,000 watts lamps must be visible from how far? - 500 feet brake lamps must be visible from - 100 feet how many flashes should turn signals be per minute? - 60-120 tag lights should be visible from - 50 feet window tint must not pass which line - AS1 line truck weight stickers are located where? - lower left Out of state inspection stickers are located where? - lower left or right of windshield toll stickers are located where - left rear window obstructions are what? - tint past AS1 line, lettering anywhere, posters signs stickers, things hanging from the mirror. vehicle must be equipped with at least how many rear view mirrors? - one mirrors shall be free of? - obstructions rear views mirrors must have a minimum surface space of? - 19.5 square inches at least a 4x5 mirror windshield defroster shall be? - im working conditions windshield washers shall be installed in vehicles produced after? - 1968 model year wipers shall be in - good working order not tattered cracked or falling apart fuel systems shall be - leak proof, intact and fastened properly accelerator control shall - be capable of returning to idle speedometer have to? - work odometers have to - work unless its over 25 years old exhaust systems - all components must be present and meet or exceed manufacturer specs and not be excessively loud, have a heat shield. fenders should not be? - in contact with the wheels hood and hood latches should - be present, cover the engine, be free of holes and lock on latch protruding objects - shall not be glass, metal or plastic dislocated or dislodged from the vehicle doors must be? - present, function as to open and close securely, unless modified to have no roof or side, tailgates can be removed if there is a net wooden plant or optional equipment present to secure contents vehicle frame shall be? - solid motor mounts shall be - not broken, crack free or missing flooring should be - able to support occupants hole free. bumpers - shall be securely attached, meet or exceed oe specs, and can be a wood plank affixed to a steel bumper seat shall be - have no springs protruding and adjusting mechanism must work safety belts should be - equipped, not frayed, and have working belt buckles
