Download PA State Inspection Categories Test Questions With 100% Correct Answers 2024 and more Exams Advanced Education in PDF only on Docsity! PA State Inspection Categories Test Questions With 100% Correct Answers 2024 How should Suspension components be maintained? - Correct Answer-every suspension component shall be in safe operating condition how should steering components be maintained? - Correct Answer-the steering component should be in safe operating conditions the steering wheel shall have a minimum outside diameter of ?? - Correct Answer-13 inches a passenger car manufactured after June 30, 1967 and designated as a 1968 or later model shall be equipped with what? - Correct Answer-service brake system with rupture failure design that doesn't not result in complete brake loss brake lines shall be approved for use as - Correct Answer- brake lines pg. 1 professoraxe l what shall a vehicle specified in this chapter be equipped with? - Correct Answer-parking brake what should a parking brake be adequate to hold the vehicle on? - Correct Answer-ice or snow on a 20% grade a radial ply tire shall not be used on? - Correct Answer-the same axle as a belted or bias tire different types of tires - Correct Answer-different types of tires shall not be used on the same axle unless in the event of an emergency Non-Pneumatic tires - Correct Answer-only if originally equipped by the manufacturer and or an antique vehicle ice grips or studs - Correct Answer-may not be equipped if they have projections greater than 2/32nds tires and rims - Correct Answer-must meet or beat manufacturer specs pg. 2 professoraxe l two adjacent tread depths of _______ or less fails a car - Correct Answer-2/32nds two adjacent tread depths of _______ or less fails a truck - Correct Answer-4/32nds what type of construction should your head lamps be in a two lamp construction? - Correct Answer-type 2 what type of construction should your head lamps be in a four lamp construction? - Correct Answer-two lamps shall be type 2 construction and two lamps shall be of type 1 one contruction what kind of dimming switch must be installed? - Correct Answer-manual dimming switch, and auto can be installed in addition to the manual switch stop lamps hazards and warning lights must be visible from? - Correct Answer-100feet pg. 5 professoraxe l lamps shall be what? - Correct Answer-properly fastened, in accordance with tables 2-4, unobstructed, ornamental lamps - Correct Answer-a no go unless they are emergency lights back up lamps cannot be? - Correct Answer-on when in forward motion registration plate lamp must be visible from - Correct Answer- 50 feet fog lamps cannot be substituted for? - Correct Answer-head lamps auxiliary driving lamp dimensions - Correct Answer-20in apart from center to center not more than 42 inches above level surface auxiliary driving lamps and fog lamps shall be aimed? - Correct Answer-in straight ahead position not above horizontal centerline of lamp at 25 feet pg. 6 professoraxe l may on have how many auxiliary driving lamps? - Correct Answer-a pair auxiliary lamps shall not be used on? - Correct Answer-snow plows, blocking a primary light, substituting head lights. snow plows lamps are wired how? - Correct Answer-through a double throw switch so they can be operated separately from head lights roof or roll bar lights installed shall not be? - Correct Answer- used on a highway, and are covered at all times antique vehicles equipped with limited OE lighting are? - Correct Answer-exempt truck weight stickers are located where? - Correct Answer- lower left Out of state inspection stickers are located where? - Correct Answer-lower left or right of windshield pg. 7 professoraxe l hood and hood latches should - Correct Answer-be present, cover the engine, be free of holes and lock on latch protruding objects - Correct Answer-shall not be glass, metal or plastic dislocated or dislodged from the vehicle doors must be? - Correct Answer-present, function as to open and close securely, unless modified to have no roof or side, tailgates can be removed if there is a net wooden plant or optional equipment present to secure contents vehicle frame shall be? - Correct Answer-solid motor mounts shall be - Correct Answer-not broken, crack free or missing flooring should be - Correct Answer-able to support occupants hole free. bumpers - Correct Answer-shall be securely attached, meet or exceed oe specs, and can be a wood plank affixed to a steel bumper pg. 10 professoraxe l seat shall be - Correct Answer-have no springs protruding and adjusting mechanism must work safety belts should be - Correct Answer-equipped, not frayed, and have working belt buckles pg. 11 professoraxe l
